Bearing rail for deck board fastening
- Maximum free span up to 1200 mm depending on the configuration. Consult DTU 51.4 and the profile's technical sheet for determining permissible spacing.
- Industrially pre-clipped profile for perfect lines
- Possibility to individually dismantle each board using special keys adapted to the board width
- Rail can be cut to length
- No contact between boards and aluminum rail, for better air circulation
- Invisible fastening
- Simplicity, speed, and ease of installation
- Infinite possibilities of use
- 100% recyclable
Technical specifications
The PR56 rail is a bearing rail dedicated to the construction of terraces in cases of significant heights. It can be laid directly on the ground or on Top Lift pedestals. Designed for configurations requiring large spans, it allows increasing the spacing between pedestals up to 1.20 m, thus offering a solution adapted to technical projects with strong height constraints.
| Rail material | Aluminum 6060 |
|---|---|
| Rail finish | Black paint |
| Clip material | Polyoxymethylene |
| Rail weight (with clips) | +/- 1.70 kg/ml |
| Max. length | 3968 mm |
| Clip pull-out resistance on the rail | 150 to 250 kg, for 2 fastening points (depending on cladding type) |
The product from every angle
Durable
Designed for high resistance, our rails maintain their integrity for many years.
Recyclable
Aluminum composed of at least 80% recycled materials.
Made in France
Our aluminum rails are manufactured in France and assembled in our factory in Alsace.
Installation Guide
Place the Elastomer strip under the PR56 to compensate for level differences and eliminate parasitic noises.
Then position the rail directly on the ground. The rails can be installed without fastening; however, in wind-exposed areas (especially by the sea), it is strongly advised to secure them with brackets.
The PR56 in pictures
